Skip to Main Content »

Search Site

Category Navigation:

You're currently on:

Ignition - Electrical

Items 1 to 10 of 13 total Page:
  1. 1
  2. 2
  3. Next
Show per page
View as: Grid  List  Sort by Set Descending Direction

Daytona Twin Tec Internal (Nose Cone) Ignition for 1971-2003 Harley Sportster

$269.99
Daytona Twin Tec Internal (Nose Cone) Ignition for 1971-2003 Harley Sportster

The Model 1005 internal ignition unit is triggered from the stock timing rotor at the end of the camshaft and mounted within the "nose cone" of the engine. This "nose cone" ignition is applicable to a wide range of H-D® engines. The Model 1005 ignition replaces all the H-D® OE ignition components including the bulky wiring harness and external module. The resulting clean appearance is especially desirable on custom motorcycles.

It is constructed with a low profile machined billet aluminum housing. Four rotary switches are used to set the operating modes (such as single or dual fire, advance curve family, and multi-spark), adjust the timing advance, and select the RPM limit. Two diagnostic LEDs indicate status and the state of the vacuum switch (VOES). The status LED is also used for static timing, as it will flash when the engine reaches top dead center (TDC).

You can adjust the slope of the advance curve. The user can optimize the timing advance for a wide range of applications - from stock to highly modified engines. For details, including advance curves, you can download the installation instructions from our website.

Switch selectable single or dual fire mode allows you to initially install the unit and run it in dual fire mode with your stock coil. You can then easily upgrade to single fire by adding an appropriate coil. If you have a tach, it will continue to operate properly (some competitive systems require that you purchase a tach adapter).

A special feature allows use of the tachometer wire for a link to a laptop PC when the engine is not running. While the customer does not require the PC link for any normal setup or operation, it can be used to access additional features for precise dyno tuning (such as programming a custom advance curve and setting rear cylinder timing offset). Our new USB interface (P/N USB-INTF) is used for this purpose. The USB interface is sold separately, but Windows compatible software is available for download. The software will operate in demo mode without an ignition attached.

Note: 1971-1982 Sportsters require the use of OEM 32402-83 ignition timing rotor.

Learn More

Add to Wishlist | Add to Compare

Plug-In Ignition for Sportster® Models with Single 12 Pin Connector for Harley Sportster

$279.99
Plug-In Ignition for Sportster® Models with Single 12 Pin Connector for Harley Sportster

· Wide timing advance adjustment range accommodates stock to highly modified engines

· Digitally set RPM limit (100 RPM steps from 3,000 to 9,900 RPM)

· Full support for J1850 data bus used for communications with instrument cluster and turn signal/security module (TSM/TSSM)

· Compatible with aftermarket tachometers

· Built-in data logging. Stores last 30 minutes of engine operation

· Extensive diagnostics. Compatible with H-D® scan tool.

· Optional USB interface and software for custom programming and data analysis.

· Billet aluminum housing with black anodized finish

· Easy plug-in installation

Learn More

Add to Wishlist | Add to Compare

Optional Twin-Tec USB Interface for Harley Sportster

$99.99
Optional Twin-Tec USB Interface for Harley Sportster

Windows compatible software allow the use of a laptop PC to program a custom advance curve for precise dyno tuning, download data logged by the unit, and access additional features such as speedometer/odometer recalibration (to accommodate tire and gear changes). The USB interface plugs into the existing H-D® diagnostic connector on the motorcycle wiring harness. The USB interface is sold separately, but Windows compatible software is available for download. The software will operate in demo mode without an ignition attached.
Learn More

Add to Wishlist | Add to Compare

Dyna 2Ki Programmable Ignition 1970-2003 Harley Sportster

$245.99
Dyna 2Ki Programmable Ignition 1970-2003 Harley Sportster

The Dyna 2Ki Programmable Ignition is the newest addition to the successful line of Dyna 2000 ignition systems. The 2Ki not only adds to, but extends many features of the best selling Dyna 2000 module out of sight in a completely new design that fits under the cam cover. Features:

Single Fire operation down to zero rpm for easier cranking and kicking.

Will operate in all combinations of single fire or dual fire with single plug or dual plug heads. (when used with appropriate coils)
8 advance curves to cover a broad range of engine builds and riding styles.

Engine over rev protection adjustable from 6000 to 7500 rpm. # Adjustable timing retard for nitrous and turbo applications. # VOES indicator. Allows you to tell at a glance the status of the VOES switch. Also indicates when retard mode is active. Great for diagnosing faulty vacuum switches or operation of retard controllers.

Built in Tach Driver. Delivers stable tach signal even during rev limiting or can be used to activate shift lights, auto shifters, and other accessories.

Easy static timing with built in timing indicator. No timing light required.

Intelligent over current / short circuit protection. Every time power to the ignition is switched on, the 2Ki will check to see if the coil is shorted, mis-wired, or the wrong type. If an error is detected, the 2Ki will imediately switch off and issue a warning by rapidly flashing the status indicator. Besides protecting the unit, this also prevents the costly failure of an improperly matched coil going bad one hour into your ride. After starting, the 2Ki countinuously monitors the coil and wiring status.

Active Dwell Control. Continually adjusts coil current to maintain maximum spark energy all the way to redline while eliminating coil stress caused by overcharging at idle. High efficiency design reduces battery draw for easier cold wheather starting and lower charging system load.
Ruggedized output - cannot be damaged by broken or disconnected spark plug wires.
Over voltage protected against momentary spikes (both positive and negative going) as well as surges caused by faulty voltage regulators or quick charge battery boosters.
Harness constructed with TXL cross linked polyethylene automotive wire for exceptional resistance to abrasion, heat, and chemical attack. High temp glass braid jacket further increases the toughness of the harness and provides a tight, clean appearance. Wire colors closely match the factory harness for error free installation.
Manufactured with premium quality components specifically qualified for operation in a high temperature / high vibration environment. A one piece aluminum housing and thermally conductive epoxy encapsulation provide superior heat dissapation and outstanding resistance to shock, vibration, and moisture.
Advanced microprocessor technology.
Quartz crystal accuracy.
Intelligent overvoltage/overcurrent protection.
Adjustable retard timing.
Short circuit protection.
Learn More

Add to Wishlist | Add to Compare

Optional Programming Kit For Dyna 2Ki Programmable Ignition for Harley Sportster

$95.99
Optional Programming Kit For Dyna 2Ki Programmable Ignition for Harley Sportster

The Dyna 2Ki Programming Kit adds full PC programmability and data recording.
-8 point fully definable wide open throttle curve
-8 point fully definable part throttle curve
-Rev limit programmable in 50rpm steps
-Programmable dead cranking revs 0-5
-Programmable Rear Cylinder offset +/- 10 degrees
-Max RPM and seconds near rev limit
-Total engine hours/time at wide open throttle
-Number of engine starts




Learn More

Add to Wishlist | Add to Compare

ACCEL SINGLE/DUAL FIRE IGNITION MODULE for Harley Sportster

$329.99
ACCEL SINGLE/DUAL FIRE IGNITION MODULE for Harley Sportster

Fits: Sportster models 1983-2003

This ignition unit works with both single or dual fire coils eliminating the need to buy a new ignition when you change coils. It has 14 preset ignition curves to cover a stock engine through exhaust and intake changes to a full blown big inch high compression motor. Other features include an easily selectable rev limiter and L.E.D. timing light for quick static timing. The harness has V.O.E.S. input, tachometer output, and is externally grounded for better reliability. The housing is machined out of aluminum for better heat dissipation. Many hours of dyno testing went into creating this ignition so that it is simple to use and delivers the premium performance you expect from ACCEL. Learn More

Add to Wishlist | Add to Compare

Dyna S Hi-Performance Ignition System for Harley Sportster

$134.95
Dyna S Hi-Performance Ignition System for Harley Sportster

Dyna S Hi-Performance ignition system is self contained, fit s behind ignition cover, and uses the magnetic rotor with the original spark advancer so the factory advance curve is maintained.

improves performance, extends spark plug life, and eliminates points and condensers.

For dual plug heads use advance mechanism, available separately.

Fits:
XL 1971-2003 Learn More

Add to Wishlist | Add to Compare

Motor Factory Billet Distributor 1957-1970 Harley Sportster

$395.99
Motor Factory Billet Distributor 1957-1970 Harley Sportster

Fits: Sportster models 1957 thru 1970

These billet aluminum distributors are available to fit 1957 thru 1970 Sportster models. Single or dual fire electronic ignition with built-in timing light, and can be used with 3 or 5 ohm coils. Front to rear cylinder is pre-timed and accurate to 1/2 degree. Operates on 10-17 volts and draws less than 1/2 amp. Sealed Hall Effect ignition is impervious to moisture and vibration. Less coil dwell time promotes longer coil life and a hot spark at any RPM. Same size as OEM auto advance distributors and installs without cylinder head removal. Features tool steel auto advance and all components are made in USA.
Learn More

Add to Wishlist | Add to Compare

ACCEL PERFORMANCE TUNE-UP KIT For Harley Sportster & K Models

$18.99
ACCEL PERFORMANCE TUNE-UP KIT For Harley Sportster & K Models

Models:
XL 1971-Early 1978
XL & K Models 1954 -1970 (except Magneto)
XL 1958-1969 (with Magneto)

ACCEL's famous high performance 32 oz. points are combined with ACCEL premium condensers to provide you with the ultimate tune-up kits for your Harley. Premium materials, stringent quality control and tough testing assure that you get peak ignition performance and reliable service.

Made in the U.S.A.

CHOOSE YOUR MODEL.... Learn More

Add to Wishlist | Add to Compare

Roller Bearing Advance Kit Harley Sportster 1971-Early 1978

$55.99
Roller Bearing Advance Kit Harley Sportster 1971-Early 1978

Models:
XL 1971-Early 1978

Smooth advance ignition timing has reached a new level of performance and reliability with our roller bearing advance kit....

Roller bearings at the pivots of the advance weights gives the proper amount of ignition advance at he right time...every time.

All the parts needed to make your ignition up-to-date with better than new performance.

Includes roller bearing weights installed on a quality advance unit shaft and plate, points cam, wiring harness, springs and timing screw.

Learn More

Add to Wishlist | Add to Compare

Items 1 to 10 of 13 total Page:
  1. 1
  2. 2
  3. Next
Show per page
View as: Grid  List  Sort by Set Descending Direction
 
My Cart

You have no items in your shopping cart.

Compare Products

You have no items to compare.